Epson EB-93 User Manual page 75

List of Functions
Submenu
Auto Setup Set to On to automatically adjust Tracking, Sync., and Position to
the optimum state when the input signal changes.
Set to Auto to automatically identify the resolution of the input
Resolution
signal. If images are not projected correctly when set to Auto, for
example if some of the image is missing, adjust to Wide for wide
screens, or set to Normal for 4:3 or 5:4 screens depending on the
connected computer.
Tracking You can adjust computer images when vertical stripes appear in
the images.
You can adjust computer images when flickering, fuzziness, or
Sync.
interference appear in the images.
Position You can adjust the display position up, down, left, and right when
a part of the image is missing so that the whole image is projected.
Function
Submenu
Progressive (This setting can only be adjusted when a component video or
RGB video with an interlaced signal (480i/576i/1080i) is input.
This cannot be set when a digital RGB signal is input.)
g
Interlace (i) signal is converted to Progressive
conversion)
Off: Ideal for images with a large amount of movement.
Video: Ideal for general video images.
Film/Auto: This is ideal for movie films, computer graphics, and
animation.
(This cannot be set when a digital RGB signal is input, or when an
Noise Reduction
interlace signal is being displayed when Progressive is set to
Off.)
Smoothes out rough images. There are two modes. Select your
favorite setting. It is recommended that this is set to Off when
viewing image sources in which noise is very low, such as for
DVDs.
When the projector's HDMI port is connected to a DVD player,
HDMI Video
the projector's video range is set according to the DVD player's
Range
video range setting.
You can select input signal from Computer port.
Input Signal
If set to Auto, the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to Auto, select the
appropriate signal according to the connected equipment.
You can select the input signal from the Video port. If this is set to
Video Signal
Auto, video signals are recognized automatically. If interference
appears in the image or a problem occurs such as no image is
being projected when set to Auto, select the appropriate signal
depending on the connected equipment.
You can set the aspect ratio
Aspect
s "Changing the Aspect Ratio of the Projected Image "
75
Function
g
(p). (IP
g
for projected images.
p.40