Advertisement
USER'S GUIDE LD (10B-A)
Stopwatch
The Stopwatch Mode lets you measure elapsed time, split
Mode indicator
times, and two finishes. The range of the stopwatch is
59 minutes, 59.99 seconds.
Minutes
Seconds
• The stopwatch continues to run, restarting from zero
after it reaches its limit, until you stop it.
• The stopwatch measurement operation continues even
if you exit the Stopwatch Mode.
• Exiting the Stopwatch Mode while a split time is frozen
on the display clears the split time and returns to
elapsed time measurement.
• All of the operations in this section are performed in the
Stopwatch Mode, which you enter by pressing B.
1/100 second
Split time
indicator
[Module 2676]
To measure times with the stopwatch
(a) Elapsed time measurement
Stop
Re-start
Start
(b) Split time measurement
Split
Split release
Start
(SPL/
displayed)
(c) Split time and 1st-2nd place times
Split
Stop
Start
First runner
Second runner
finishes.
finishes.
Display time of
first runner.
• Pressing A also illuminates the display.
Time Setting
Use the Time Setting Mode to set the current time and
PM indicator
date.
Day of the week
Day
To set the time and date
1. Use B to enter the Time Setting Mode.
• The second's digits flash because they are selected .
2. Press A to change the selection in the following
sequence.
• Pressing A also illuminates the display.
Seconds
Day of week
Hour
Minutes
Seconds
3. While the second's digits are selected (flashing), press C to reset the seconds to
"00". If you press C while the second's count is in the range of 30 to 59, the
seconds are reset to "00" and 1 is added to the minutes. If the second's count is in
the range of 00 to 29, the minute's count is unchanged.
4. While any other digits (besides seconds) are selected (flashing), press C to
increase the number. While the day of the week is selected, pressing C advances
to the next day. Holding down C changes the current selection at high speed.
5. After you set the time and date, press B to return to the Timekeeping Mode.
• If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Timekeeping Mode automatically.
Stop
Clear
Stop
Clear
Split release
Clear
Display time of
second runner.
Hour
Minutes
Day
Month
2
Advertisement
