Table of Contents
Advertisement
Installation
Inspection
Damage
When you receive your power supply, inspect it for any obvious damage that may have occurred during shipment. If there is
damage, notify the shipping carrier and the nearest Agilent Sales and Support office immediately. Warranty information is
printed in the front of this guide.
Save the shipping carton and packing materials in case the power supply must be returned to Agilent Technologies. If you
return it for service, attach a tag identifying the model number and the owner. Also include a brief description of the
problem.
Items Supplied
In addition to this manual, check that the following items are included with your power supply (see Table 1-4 for part
numbers):
Power cord
Your power supply was shipped with a power cord for the type of outlet specified for your location. If the appropriate cord
was not included, contact your nearest Agilent Sales and Support office (see end of this manual) to obtain the correct cord.
Your power supply cannot use a standard power cord. The power cords supplied by Agilent
Technologies have heavier gauge wire.
Series 657xA Only
These power supplies also include output hardware (screws with nuts and lockwashers) for securing your load wires to the
output bus bars (see Table 1-4).
Manual Change Page
If applicable, change sheets may be included with this manual. If there are change sheets, make the indicated corrections to
this manual.
Location and Cooling
Bench Operation
The "Supplemental Characteristics" in Chapter 1 give the dimensions of your power supply. The cabinet has plastic feet that
are shaped to ensure self-alignment when stacked with other Agilent System II cabinets. The feet may be removed for rack
mounting. Your power supply must be installed in a location that allows sufficient space at the sides and rear of the cabinet
for adequate air circulation. Minimum clearances are 1 inch (25 mm) along the sides. Do not block the fan exhaust at the
rear of the supply.
Rack Mounting
The power supply can be mounted in a standard 19-inch rack panel or cabinet. Rack mounting kits are available as Option
908 or 909 (with handles). Installation instructions are included with each rack mounting kit. Instrument support rails are
required for non-stationary installations. These are normally ordered with the cabinet and are not included with the rack
mounting kits.
2
Installation 27
Advertisement
Table of Contents
