For functions not described in this Guide, refer to the Precautions ..............3 Instruction Manual on the following website: Safety Precautions and Important http://manual.kenwood.com/edition/im382/ Information .............. 5 To refer to Instruction manual, a PC loaded with First Step ............... 6 Microsoft®...
• When you purchase optional accessories, check play. In such a situation, remove the disc and wait with your Kenwood dealer to make sure that they for the condensation to evaporate. If the unit still work with your model and in your area.
The unit returns to the factory settings. first time. This process could take up to several DNX5350BT minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition.
Neither other factors that may affect safety or timing while Kenwood nor Garmin shall be liable for problems driving. or accidents resulting from failure to observe the Use the navigation system only as a navigational aid.
Touch [Finish]. First Step ✎ NOTE Various setup screens appear automatically before • “Initial setup”also appears when the unit is reset. using. Ñ Initial setup When you first turn on the unit, the screen of the configuration setting will appear. Turn the ignition key of your car to ACC.
Ñ iPod/iPhone connection setup Ñ Application link setup When you first select iPod as a source, the setting When you first select Apps as a source, the setting screen of the iPod/iPhone connection will appear. screen for the connection with the device installed the apps will appear.
Functions of the Buttons on the Front Panel Ñ DNX5350BT Name/Motion Name/Motion 7 R , S 1 Disc insert slot • A slot to insert a disc media. • Adjusts volume. 8 TEL • Ejects the disc. • Displays the Hands Free screen (Instruction •...
Page 9
Ñ DNX5350DAB Name/Motion Name/Motion 1 Disc insert slot 7 TEL • A slot to insert a disc media. • Displays the Hands Free screen (Instruction Manual P.72). • Pressing for 1 second displays the Voice • Ejects the disc. Recognition screen. (Instruction Manual •...
Page 10
Ñ DNX535VBT Name/Motion Name/Motion 1 G (Eject) 7 Reset • Ejects the disc. • If the unit or the connected unit fails to • Pressing for 1 second ejects the disc forcibly. operate properly, the unit returns to factory settings when this button is pressed 2 MENU (Instruction Manual P.109).
Page 11
Name/Motion t SI indicator • If the Security Indicator (SI) function is turned on, this indicator flashes when the panel is detached (Instruction Manual P.83). * The display may not switch to the Graphic Equalizer screen in some conditions. English ñ...
SD Card it toward the front side as shown in the diagram above. If it is detached upward, the front panel Ñ DNX5350BT will be broken. Detaching the faceplate • To prevent deterioration, do not touch the...
Page 13
Insert a microSD Card Ñ Eject a SD Card/ microSD Card 1) Open the card slot cover. 1) Push the card until it clicks and then remove 2) Hold the microSD card with the label side your finger from the card. facing right and the notched section down, 2) The card pops up so that you can pull it out and insert it into the slot until it clicks.
Common Operations etc. Touch keys with various functions are displayed here. Ñ General Displayed keys differ depending on the current There are some functions which can be operated audio source, status, etc. from most screens. For examples, see List screen (P.20) in the Instruction Manual.
Garmin and JVC KENWOOD will not be responsible for any traffic fines or citations that you may receive for failing to follow all applicable traffic laws and signs.
• Touch and drag the map to view a different area of You can purchase updated map data from the map. Garmin or ask your Kenwood dealer or • A speed limit icon could appear as you travel on Kenwood service center for details.
✎ USB device NOTE 1) Connect the USB device with the USB cable. • For other operations, refer to the Instruction Manual. • If desired key is not displayed in the multi-function bar, touch the [ ] to switch the menu. Search the track/file you want to listen to.
Connect the media you want to play. Touch [Menu] on any screen. For the method of connecting, see How to Play Top Menu screen appears. Music (P.16). Touch [DAB] (DNX5350DAB only) or Control the movie/picture by touching [TUNER]. the screen. The unit switches to the radio source.
1) Touch [P#]. 6) Enter PIN code form the cell-phone. You can also display the preset list by Registering is completed. touching the frequency display in the center. The PIN code is set to “0000” as default. ✎ NOTE Connect your cell-phone to the unit. •...
1) Touch [Preset #] to start calling the Installation corresponding phone number. 2) Touch [ Ñ Before Installation Call by voice Before installation of this unit, please note the You can make a voice call using the voice following precautions. recognition function of the cell-phone.
Otherwise scars, damage, or failure may result. • Reception may drop if there are metal objects near the Bluetooth antenna. DNX5350BT DNX535VBT DNX5350DAB DNX5350BT only DNX535VBT only DNX5350DAB only region code 2/3 area only Bluetooth antenna unit English ñ...
Page 22
Ñ Unit Ñ Trim plate (DNX5350BT, DNX5350DAB) 1) To prevent a short circuit, remove the key from 1) Attach accessory 6 to the unit. the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit.
Page 23
Ñ GPS antenna Ñ Microphone unit GPS antenna is installed inside of the car. It should 1) Check the installation position of the be installed as horizontally as possible to allow easy microphone (accessory 9). reception of the GPS satellite signals. 2) Clean the installation surface.
Installation overview Ñ Installation the Digital Radio antenna (DNX5350DAB) #CAUTION • This film antenna is exclusively for use inside the vehicle. • Do not install at the following locations: – Where it may block driver’s view – Where it may obstruct operation of safety devices such as air bags –...
Page 25
When installing the antenna on the right side (accessory -) vertically and paste the antenna gently while applying pressure. Earth sheet 150 mm 70 mm * 5) After pasting, rub the element in the glass surface in the direction of the arrow shown in the figure to bond it.
Page 26
✎ NOTE When installing the antenna on the left side • Take the following precautions when passing the antenna cable inside the front pillar where the air bag is installed. – Install the amplifier part of the antenna Earth sheet cable in front or above the air bag so that the antenna and the air bag do not interfere.
Accessory 3: GPS Antenna Digital radio antenna Accessory 9: Bluetooth Microphone FM/AM antenna input Rear View Camera Input Accessory 0 (DNX5350BT, DNX5350DAB): Steering remote harness AV Video Output Connect to vehicle’s steering remote Rear Audio Preout harness. Contact your Kenwood dealer for details.
Ñ Connecting wires to terminals (DNX5350BT, DNX5350DAB) Fuse (10A) Ignition key switch Accessory 1 Red (Ignition wire) White/Black Yellow (Battery wire) To front left speaker Car fuse White Car fuse Black (Ground wire) ¤ (Main fuse) (To car chassis) Gray/Black...
Page 29
Ñ 3 way speaker system setup (DNX5350BT Region code 3 area only) ✎ NOTE • For how to connect speaker wires to terminals other than speaker terminals and Preout terminals, see “System connection” (P.27) and “Connecting wires to terminals (DNX5350BT, DNX5350DAB)” (P.28).
Page 30
Switching between speaker systems The 2 way speaker system is switched to the 3 way speaker system. Switch to the 3 way speaker system following the procedure below. ✎ NOTE • When the 3-way speaker system is selected, ✎ NOTE the following functions are disabled.
Page 31
Ñ Connecting wires to terminals (DNX535VBT) Connector Function Guide Fuse (10A) Pin Numbers Cable Color Functions for ISO Connectors External Power Connector Yellow Battery Blue/White Power Control Orange/White Dimmer Ignition (ACC) Black Earth (Ground) Accessory 2 Connection A: Black (Ground wire) B: Yellow (Battery wire) Speaker C: Red (Ignition wire)
Ñ Optional accessory connection USB maximum power supply current : DC 5 V = 500 mA Sold separately Optional accessory KCA-MH100 (1.8 m) Android smartphone KCA-HD100 (1.8 m) iPod/iPhone Video Output (1.8m) USB terminal (0.8 m) iPod Lightning Digital AV Adapter USB device Apple 30-pin Digital AV Adapter KCA-iP102...
Bluetooth SIG, Inc. and any use of such marks by Certified® device must be registered in order to play JVC KENWOOD Corporation is under license. Other purchased DivX Video-on-Demand (VOD) movies. trademarks and trade names are those of their To obtain your registration code, locate the DivX respective owners.
Page 34
Ñ Requirements Pandora®: • libFLAC Copyright (C) 2000,2001,2002,2003,2004,2005,2006,2 Requirements for listening to the Pandora® are as 007,2008,2009 Josh Coalson follows: Redistribution and use in source and binary forms, iPhone or iPod touch with or without modification, are permitted • Use an Apple iPhone or iPod touch running under provided that the following conditions are met: iOS3 or later.
Page 35
Ñ Android connection applications can be controlled from this unit. The operable functions depend on the application. To connect the Android device with this unit, Refer to “Apps Operation” (P.50) in the Instruction the cable (sold separately) and the profile which Manual.
JVCKENWOOD NEDERLAND B.V. Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands English Hereby, JVC KENWOOD declares that this unit DNX5350BTM, DNX535VBTM is in compliance with the Sembollü (üzerinde çarpı işareti olan çöp kutusu) essential requirements and other relevant provisions ürünler ev atıkları olarak atılamaz.