Brookstone Slimline Music System User Manual page 21

I wANT TO...
Manually sync the
remote and speaker
(continued) .
Play an alternate audio
source through the speaker
using the aUX 1 input .
DO ThIs...
8 . Release the CONNECT button and press SEL
on the remote once (these instructions are also
on the remote screen) . During the Sync mode,
the blue LED will continue to flash and "Sync in
progress" will be on the remote screen . Keep the
remote close to and pointed directly at the front
of the speaker . The Sync mode may take several
seconds . When the Sync process is complete,
the blue LED will stop flashing but remain lit
and "Sync Complete" will appear on the remote .
The remote and iPod/iPhone are now synced .
note: When the speaker is searching for
the remote or if there is no signal, the leD
on the front of the speaker will blink slowly.
note: Press the menu button on the remote
to return to the previous menu at any time.
Plug one end of a 3 . 5 mm to 3 . 5 mm cable
(not included) into the aUX 1 input on the rear
of the speaker and the other end into the 3 . 5 mm
output on the alternate audio source .
20