Page 1
SRE 150 E MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D’USO > GEBRUIKSAANWIJZING...
Page 2
AFNOR CERTIFICATION 11, AVENUE FRANCIS DE PRESSENSE 93571 SAINT-DENIS LA PLAINE CEDEX FICHE INFORMATIVE La marque NF garantit la qualité de cet article suivant les normes françaises CHAUFFAGES MOBILES et Règlement de certification A COMBUSTIBLE LIQUIDE de l’application NF 128 NF 128 02 / 02 CONFORME A LA NORME NF D 35-300 ET AUX SPECIFICATIONS COMPLEMENTAIRES DEFINIES PAR LE REGLEMENT...
Page 3
Dear Sir, Madam, Congratulations with your purchase of this Zibro heater. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro heater.
• The right quality of fuel will be assured, when you SAVE key use Zibro Extra or Zibro Kristal for your heater. • If you change to another brand and/or type of Air quality control parrafin oil, you must first finish up all the system remaining fuel in the heater.
Only use Class C1 paraffin fuel in accordance with BS2869; Part 2, or equivalent. Your heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Only fuels of this kind will ensure clean and proper burning. Lower quality fuel may result in:...
MANUAL INSTALLING THE HEATER Carefully remove your heater from the box and check the contents. In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for use Keep the box and the packaging materials (Fig. A) for storage and/or transportation.
Check the removable tank fuel gauge while filling the tank (Fig. D). Stop filling by loosening the switch button on top of the pump (turn anti-clock- wise), once the gauge indicates that the tank is full. Never overfill the tank, especially not when the fuel is very cold (fuel expands when it heats up).
The available temperature settings range from 6°C minimum to 28°C maximum. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. USING THE TIMER The timer allows you to switch on the heater automatically at a preset time. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off.
f - 1 Faulty burner thermistor. Contact your dealer. e - 2 Starting problems. Contact your dealer. e - 5 Tipping-over protection. Re-ignite the heater. e - 6 Poor burning. Contact your dealer. e - 7 Room temperature If necessary, above 32°C.
Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. THE 'FUEL' INDICATOR When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use.
Do not remove any heater components yourself. Always contact your dealer for repairs. When the power cord is damaged, it may only be replaced by an authorised fitter. Use a new cord of the type H05 VV-F. STORAGE (END OF THE HEATING SEASON) At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging.
Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. The warranty shall no longer apply, when the heater has been modified, non-original parts have been used, or when it is repaired by third parties. The warranty shall not apply to parts that are subject to normal wear, such as the burner mat and the manual fuel pump.