Sekonic FLASH MASTER L-358 Opearting Manual page 32

3. The set channel number will blink at this time.
Turn the Jog wheel to set the channel setting.
4. In the Setting mode, "ch" appears on the ISO display area. At the same time, channel numbers
(1 to 16 and 17 to 32) appear on the F stop area. When the channel number is 17 to 32, sub-
channel (A, b, c and d) settings are displayed on the T indicator. In the absence of settings, "-
" appears in the figures.
5. In sub-channel settings, after the channel is set to 17 to 32, the mode button is pressed. Following
this, the 4th figure on the T (shutter speed) area blinks to indicate that settings may be made.
Every time the mode button is pressed, the blink shifts from sub-channel No. 4th figure
figure 2nd figure
As the Jog wheel is rotated in this state, setting ("A, b, c and d" displayed) and resetting ("-"
displayed) alternate. During this process, the indicator continues to blink to indicate the channel
being set.
CAUTION
• When using quad channels 17-32, it is not possible to terminate this mode unless a sub-
channel has been set (a, b, c or d is displayed).
1st figure channel No., while permitting settings for each sub-channel.
6. Advanced Functions
Set by manipulating the mode set button.
Set by manipulating the Jog wheel.
3rd
-29-