Related Manuals for InStyler 3/4 in. (19mm) InStyle
Summary of Contents for InStyler 3/4 in. (19mm) InStyle
- Page 1 IMPORTANT! For best results, go to www.instyler.com click on Video Tips & Techniques USER MANUAL 3/4 in. (19mm) InStyler Rotating Iron ®...
-
Page 2: Important Safety Information
1. ALWAYS UNPLUG IT IMMEDIATELY AFTER USING. 2. DO NOT use while bathing or showering. 3. DO NOT place or store InStyler Rotating Iron where it can fall or be pulled into a tub, toilet or sink or any other water source. 4. DO NOT use InStyler Rotating Iron near water. - Page 3 ONLY, with the following precautions. If your real human hair extensions are sewn in, you can use your InStyler up to the scalp. If your real human hair exten- sions are glued in, make sure you start with your InStyler below the glue.
-
Page 4: Introduction And Getting Started
Introduction and Getting Started CONGRATULATIONS! You have just purchased the most versatile hairstyl- ing tool available today. From sleek, smooth styles to glamorous, curly looks, and everything in between, the InStyler is the only tool you’ll need for dynamic, fabulous styles every day! “Go Slowly!“... - Page 5 First Row of Bristles Plate Separates and Aligns Hair Automatically Aligns to Smooth Hair and Second Row of Bristles Reduce Frizz, Without Adds Volume and Reduces Frizz Swivel Cord Crushing or Creasing. Automatic Safety Shut-Off Voltage: 120V/60Hz Power: 35W For more tips, tricks and videos visit, www.instyler.com...
- Page 6 Rotate the Thermal Guard Training Aid until tabs are seated in the indentations on the body of the InStyler, and the Thermal Guard Training Aid is facing out. 4. Once it is snapped in place, you can use your InStyler as you normally would.
- Page 7 Hair Types The way you use your InStyler depends on what type of hair you have. You’ll get the most out of your InStyler if you use the techniques best suited to your hair type. The three main types of hair are: Fine - Set the InStyler at Low to Medium heat setting. With fine hair, you should only need 1 to 2 passes with the InStyler to achieve your desired results.
- Page 8 3/4 in (19mm) InStyler Rotating Iron ® Sectioning Hair To achieve the style you want with your InStyler, it is important to know how to properly section the hair. • With longer hair, clip up the top layers of your hair, and then begin sectioning and styling your under layers of hair first.
- Page 9 (see illustration) Near the end of the hair section, rotate your wrist so the InStyler brush turns out away from your face. Allow the barrel to rotate 3 to 5 seconds in place on your ends before releasing the hair.
-
Page 10: Volume Boost
6 for Thermal Guard Training Aid removal instructions.) Being careful to not burn your fingers, wrap a section of hair around the barrel of your InStyler from root to ends, with the barrel side facing your scalp (see illustration). - Page 11 • With the InStyler barrel facing towards the back of the head, close the InStyler onto the section of hair, and slowly pull the InStyler in the opposite direction that you want your hair to lay. In other words, at the crown of your head, grab a section of hair with the InStyler and slowly pull the unit forward towards your forehead.
-
Page 12: Frequently Asked Questions
® Frequently Asked Questions How do I use the InStyler as compared to my flat iron? The technique is similar in that you put your hair into the InStyler, you close it onto your hair, and then slowly move down the length of your hair. That is where the similarities end!! The rotating, heated, polishing barrel and bristles will do most of the work for you. - Page 13 I see smoke coming from my hair! Is it burning my hair? No! The InStyler is not burning your hair. This is just a byproduct of the evaporation of built-up conditioner or styling products on your hair and it is completely normal. Can I use my InStyler with real human hair extensions? Yes. Make sure you start with your InStyler below where the extension is attached to your natural hair. Do not pull the InStyler through with any pressure, as you may pull out your extensions if not careful.
- Page 14 We get asked this question a lot, and we’re very proud to say you can add this one to the old “hair styling myths” column! With the InStyler, you don’t need a lot of heat to straighten and style your hair! The InStyler’s unique design actually allows you to use less heat than you are used to, while still getting better results than you would with a flat iron or other hot tool.
- Page 15 What if my InStyler does not heat? Check to make sure your InStyler is plugged in. Press the Power button. The LED bars should light and start flashing. When the LED stops flashing the InStyler will be at the set temperature and ready to use. When I use my InStyler, why does the temperature LED start to flash? It is normal for the heat to fluctuate during use. As long as the InStyler has been allowed to reach full heat (steady LED) after powering on, you can continue to use your InStyler while it is flashing.
- Page 16 Features and Benefi ts for InStyler Models InStyler 1¼in. (32mm) Rotating Iron InStyler ¾in. (19mm) Rotating Iron • Straightens with body • Straightens with body • Creates perfect soft curls • Great for straightening close to the root • Works with all hair types • Creates perfect spiral curls • Works on all hair lengths, Works • Works with all hair types especially well with medium to long hair • Works on all hair lengths, Works styles especially well with short hair styles • Creates softer fl ip under and fl ip out • Creates tighter fl ip under and fl ip out styles styles • Great for volume boost at the crown...
Need help?
Do you have a question about the 3/4 in. (19mm) InStyle and is the answer not in the manual?
Questions and answers