To Replace Batteries - Hasbro Surfer Talkin' Squirt AGE 3+ Manual

TO REPLACE
TO REPLACE
BATTERIES
BATTERIES
Use a Phillips screwdriver to
loosen screw in battery
compartment door (screw
remains attached to door).
Remove door and remove old
batteries. Insert 3 x 1.5V fresh
"AA"/LR6 alkaline batteries.
Replace door and tighten screw.
CAUTION:
1) Be sure to insert the batteries correctly and always follow the toy
and battery manufacturer's instructions.
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries.
3) Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
1) Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2) Do not mix old batteries and new batteries, or standard (carbon-zinc)
with alkaline batteries.
3) Remove exhausted or dead batteries from the product.
4) Remove batteries if product is not to be played with for a long time.
5) Do not short-circuit the supply terminals.
6) Should this product cause, or be affected by, local electrical
interference, move it away from the other electrical equipment.
Reset (switching off and back on again or removing and re-inserting
batteries) if necessary.
7) RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
TO AVOID BATTERY LEAKAGE