Download Print this page

Pro-Ject Audio Systems Pro-Ject Tube Box SE Instructions For Use page 2

Phono amplifier

Advertisement

Dear music lover,
thank you for purchasing a PRO-JECT AUDIO Tube Box SE phono amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Setting the cartridge mode
The Tube Box must be used in either MM (moving magnet) or MC (moving coil) mode according to the
construction principle of the pickup cartridge to be used. Since most cartridges use the MM (moving magnet)
principle the Tube Box is factory set to operate in this mode. To find out which type your cartridge is please
consult the literature accompanying your cartridge. The literature for MC cartridges should also specify the
correct impedance into which the cartridge is designed to work. If in doubt please consult your dealer.
The following settings are available:
MM / 47kOhm
MC/ 100 Ohm
MC/ 220 Ohm
MC/1kOhm
Use the switches located on the underside of the
Tube Box as shown to set the appropriate mode.
Before resetting switches the unit must be disconnected from the power supply and amplifier!
Connecting the record player
Connect the tonearm signal lead to the IN of the Tube Box.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left
channel black or white. The earthing wire of the tonearm lead should be connected to the earth terminal.
Tube Box SE
2
© Audio Trade GmbH · Pro-Ject Tube Box SE · Revision 28.4.06/1.5.06
1
MM/47kOhm
0
1
MC/100 Ohm
0
1
MC/220 Ohm
0
1
MC/1kOhm
0
POWER
AC 16V
IN
OUT
LEFT
RIGHT

Advertisement

loading

This manual is also suitable for:

Tube box se