Safety instructions Your new fridge may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety.
Description of the Appliance Model ZC370RM3 Glass shelf Bottle shelf Vegetable drawer Egg tray Dairy compartment Ventilation grille Door shelf + box Door shelf Control Panel A. Green indicator lamp B. Thermostat control Lights when the fridge is operating. Use to switch on and set the desired temperature in the fridge.
Using the fridge To start the fridge and set the correct temperature Turn the thermostat control to the desired position. MIN The lowest position of the thermostat control results in the highest temperature inside the cabinet. MAX The highest position of the thermostat control results in the lowest temperature inside the cabinet.
Cabinet interior The shelves and door compartments are removable and can easily be re-arranged. Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the vegetable drawer must not be moved. They are required for proper air circulation inside the cabinet.
Maintenance and Cleaning Removing the ventilation grille The ventilation grille can be removed, e.g. to wash the grille. Make sure the door is open when removing the ventilation grille. Unsnap the upper edge of the grille by pulling outward/downward. Then pull the grille straight out to completely remove it.
doors ajar to prevent unpleasant smells. When the appliance is not in use If the cabinet will be kept on, ask somebody to Disconnect the appliance from electricity supply. check it once in a while to prevent the food inside Empty all foods and clean the appliance, leaving the from spoiling in case of a power failure.
Sound level in cabinet is too high. The refrigerating system will always produce some sounds. A pulsing sound is heard when coolant is pumped inside the cooling pipes. A ticking sound from the thermostat can be heard when the compressor switches on and off. The sound level varies depending on the operation of the cabinet.
BELGIUM for the country concerned and that they can Bergensesteenweg, 719 - 1502 LEMBEEK withstand the local climatic and environmental Tel. 02.3630444 Technical specification Model ZC370RM3 360 l Net volume 595 mm Width Height 1800 mm 600 mm...
Remove the transport supports Remove the tape and the transport supports from · the door sides · inside the door hinges · the shelves Remove the transport support on the glass shelf by pushing the support forward along the edge of the shelf until it stops.
Door Reversal 1. Close the cabinet and remove the plug from the electrical socket. 2. Remove the ventilation grille. There is a part on the grille that can be removed. Remove and reposition it on the other side. 3. Put the cabinet on a wooden board when it is laid down.
Need help?
Do you have a question about the ZC370RM3 and is the answer not in the manual?
Questions and answers