Installation; Caution; Location; Rear Spacers - Zanussi ZF 26/6 D Instruction Booklet

INSTALLATION

Caution

If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance. This will prevent it from becoming a
death-trap for a child.

Location

Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc.
Best results are obtained with a room temperature
ranging between +18 C and +43 C.
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For a more efficient operation of the appliance, the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any,
should be at least 100 mm (see Fig. 1 - A).
However, the best solution would be that shown in
Fig. 1 - B with no overhanging furniture.
Two adjustable feet make it possible to accurately
level the appliance.
A
B
D042

Rear spacers

(Fig. 2)
In the plastic envelope containing the Operating
Instructions are also included two wall spacers to be
fitted into the special openings provided on the back
of the appliance.
Push-fit the spacers into the openings, making sure
that arrow (A) is positioned as per Fig. 2 and then
turn the spacers through 45 until they lock in
(arrow (A) in a vertical position).
4
Fig. 1
A
45°
D039

Power connection

Before plugging in the appliance to the mains
socket, check that the voltage and frequency
indicated on the appliance's rating plate are the
same as those provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable.
For operation at different voltages, a suitable
transformer should be used.
The appliance MUST be connected to an efficient
earth or ground tap.
The supply-lead plug in fact incorporates a special
earth or ground contact for this purpose. If by any
chance the sockets of your domestic wiring system
are not earthed, the appliance must be connected to
a separate earth or ground wire by a qualified
electrician, in accordance with existing safety
regulations.
The manufacturer declines to accept any liability if
this accident-prevention procedure is not followed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents which
will leave an odour or abrasive powders on the
interior, as these will damage the finish.
Fig. 2