WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
Cleaning the interior Fresh food refrigeration Before using the appliance for the first time, wash To obtain the best performance: the interior and all internal accessories with luke- ¥ do not store warm food or evaporating liquids in warm water and some neutral soap so as to remove the refrigerator;...
Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
MAINTENANCE Periods of non-operation Unplug the appliance before carrying out any maintenance operation. When the appliance is not in use for long periods, take the following precautions: Periodic cleaning remove the plug from the wall socket; Clean the inside with warm water and bicarbonate of soda.
CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check ¥ If your appliance is still not working properly after that: making the above checks, contact the nearest service centre. ¥ the plug is firmly in the wall socket and the mains power switch is on;...
INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A).
Door reversal Unplug the appliance before all operations. To reverse the door, proceed as follows: 1. dismantle the lower hinge (3), pin (1) and the screw (2); 2. slide the door out from pin (G),unscrew the pin and reposition on the opposite side; 3.