Table of Contents
Advertisement
• Mag identification system
Determined by the combination of magnets in receivers located abo-
ve the drive wheel on the mag throat
( same combinations than the 400 ft magazine ).
• Footage
A sensor coupled to an external display, allows to verify the remain
footage in the magazine.
The XP 5.13 software ( installed on XTRprod cameras from serial
number C 2127 ) allows to adjust the LCD display of the camera
on 800 ft. With the earlier XTRprod, you must install this new
software ( delivered with the magazine ).
THE MAGAZINE
Warning : when you install the
platter, be sure that the edge of
the platter is placed on top of
the driving roller. An incorrect
positioning could create some
take-up problems.
Note : with XTR and
XTRplus cameras, the
LCD display does not
indicate the remaining
footage in the 800 ft
magazine. This function
is strictly reserved to the
XTRprod.
63
Advertisement
Table of Contents
