Delay Start Button - Zanussi FL 12 Instruction Booklet

- Incorrect option selection. If an option
which is not compatible with the set wash
programme is selected, the message Err is
displayed.
10 START/PAUSE button
This button has three functions:
a) Start
After having selected the required wash
programme, press this button to start the
machine; the display stops flashing.
b) Pause
To interrupt a programme which is running,
press the START/PAUSE button: the figures
displayed will start to flash.
To restart the programme from the point at
which it was interrupted, press the
START/PAUSE button again.
c) Empty out water
At the end of a programme which stops with
water in the drum (RINSE HOLD option), or after
the soak programme, press the START/PAUSE
button to empty out the water: after a soak
programme, the machine will empty only; after
RINSE HOLD programmes, the machine will
empty and spin.
12

11 DELAY START button

This button allows starting of the machine to be
delayed by a maximum of 19 hours.
The button must be pressed before pressing
the START/PAUSE button.
The figures indicating the required delay appear
in the display next to the button. After one
minute, the machine starts its countdown (every
hour).
During the last hour, the remaining time is
displayed every 5 minutes.
The delayed start function cannot be used with
the SPIN and DRAIN programmes.
To modify or cancel the preset delay, press the
START/PAUSE button, then press the DELAY
START button until the required value is
displayed or, if you wish to cancel the delay, until
the symbol h is displayed.
Then press the START/PAUSE button again.
When the delay is cancelled, the display shows
the duration of the wash programme previously
selected.
12 Operating pilot lights
The pilot lights come on individually, or in
groups, according to the options selected.
The pilot lights flash for about three seconds if
wash options are incorrectly selected. The
message Err is displayed.