Something Not Working - Zanussi ZDT110 User Manual

156997240en.qxp 12/27/2006

Something not working

IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and see which fault code is active.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code / malfunction
The dishwasher does not fill with
water.
- 1 intermittent audible signal
- 1 flash of the "end of cycle"
indicator light
The dishwasher will not drain.
- 2 intermittent audible signals
- 2 flashes of the "end of cycle"
indicator light
- 3 intermittent audible signals
- 3 flashes of the "end of cycle"
indicator light
The programme does not start.
Once these checks have been carried out; switch on the dishwasher, press the
Programme/Cancel button and close the door. The programme will continue from the point at
which it was interrupted. If the malfunction or fault code reappears contact the Service Force
Centre.
For other combinations of fault codes not described in the above chart, please contact your
Service Force Centre.
18
1:39 PM Page 18
Possible cause
The water tap is blocked or furred
with limescale.
The water tap is turned off.
The filter (where present) in the .
threaded hose fitting at the water
inlet valve is blocked.
The water inlet hose has not been
correctly laid or it is bent or
squashed.
The sink spigot is blocked.
The water drain hose has not been
correctly laid or it is bent or
squashed.
Anti-flood device is activated.
The dishwasher door has not been
properly closed.
The main plug is not plugged in.
The fuse has blown in the household Replace the fuse.
fuse box.
Solution
Clean the water tap.
Turn the water tap on.
Clean the filter in the.
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain hose
connection.
Close the water tap and
contact your local Service
Force Centre.
Close the door
Insert the mains plug