Etup; Ac Power; Fuse Replacement; Mounting - Chauvet Scorpion Storm RGX User Manual

3. S

ETUP

AC Power

This product has an auto-switching power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line
voltage you are applying is within the range of accepted voltages. This product will accommodate
between 100V and 240V AC 50-60 Hz. All products must be powered directly off a switched circuit
and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0 to
100% switch.

Fuse Replacement

With a flat head screwdriver, wedge the fuse holder
out of its housing. Remove the damaged fuse from
its holder and replace with exact same type fuse.
Insert the fuse holder back in its place and
reconnect power.
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.

Mounting

Orientation

This product may be mounted in any safe position, provided there is adequate room for ventilation.

Rigging

It is important never to obstruct the fan or vents pathway. Mount the
product using, a suitable "C" or "O" type clamp. Adjust the angle of
the product by loosening both knobs and tilting the product. After finding the
desired position, retighten both knobs.
Scorpion™ Storm RGX User Manual

When selecting installation location, take into consideration
access and routine maintenance.

Safety cables must always be used.

Never mount in places where the product will be
exposed to rain, high humidity, extreme temperature
changes
or restricted ventilation.
.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
10
Hanging Clamp
Note!
Clamp is sold separately.
8/18/2011