Cisco Catalyst Express 520 Getting Started Manual page 11

Step 6 After you click Submit, these events occur:
The Express Setup program ends.
•
The connection between the switch and
•
your PC or laptop ends.
If your PC or laptop is connected to a
•
DHCP server, your PC or laptop loses its
IP address that was used during the initial
setup.
Your browser session displays an error
•
page.
Verify that the ADMIN LED is off, which
means that the switch is configured with the
IP address that you entered in the Express
Setup window and that the initial setup is
complete.
Troubleshooting:
If the ADMIN LED continues to blink green,
it means that the switch is still not configured
with an IP address. Repeat
If the problem persists:
Disconnect the Ethernet cable from the
1.
switch.
Repeat Step 3
2.
Step 7
Assign an IP address to your PC or laptop. Make sure that the IP address that you assign is in
the same network as the switch IP address (assigned in
To change the IP address of your PC or laptop, either
Connect your PC or laptop to the network where a DHCP server allocates IP addresses
•
within the range that is assigned to your switch.
Enter a static IP address through your PC or laptop Control Panel.
•
78-18063-02
Step 1 to Step
to Step 5.
Getting Started Guide for the Catalyst Express 520 Switches
SY ST
SYST
ALRT
AL RT 1
PoE 2
3
4
Po E 5
6
ADMI N
7
POW ER
OVER ETH ERN
ET
AD MI N
5.
Step 5).
Set Up the Switch
8
Ca tal ys
t Ex pre
ss 52 0
Ser ies
1
7