Zanussi FE 1025 G Instruction Booklet page 9

5 "Start/Pause" button
After having selected the programme and the
required options press this button to start the
machine. The corresponding pilot light stops flashing
and remains lit.
To interrupt a programme which is running, depress
the Start/Pause button: the corresponding pilot light
starts to flash.
To restart the programme from the point at which it
was interrupted, press the START/PAUSE button
again.
6 Programme progress display
By selecting the wash programme, the pilot lights
corresponding to the various phases making up the
programme come on.
After the machine has started, only the running
phase pilot light stays on.
: when this light comes on this means
/
that the machine is performing the washing
phase. If you have selected the "Prewash"
function, this light will be on during the prewash
phase too.
= rinses
= spin
= drain
= end of programme
At the end of the programme the
illuminates.
The pilot light also flashes in the event of
operating problems:
- 4 flashes = the door has not been closed
- 2 flashes = the machine does not empty
- 1 flash = the machine does not fill
To eliminate the problem, see paragraph "Something
not working".
7 "Spin speed" selector dial
By means of this dial you can reduce the final spin
speed or select "NO SPIN" position
The spin speeds on the dial refer to cotton
programmes.
Position 1000 corresponds to 900 rpm for synthetics
and wool and to 700 rpm for delicates.
Position 500 corresponds to 500 rpm for synthetics
and wool and to 400 rpm for delicates.
NO SPIN position: by turning the dial to position
the machine will not spin. This function can be used
for extremely delicate items.
The machine will perform 3 extra rinses for cotton
and 1 extra rinse for synthetics.
Important:
If you have selected spin programme
selector dial
the machine will perform a short spin at 400 rpm.
8 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetics
• Delicates
• Wool
• Special programmes
O Reset programme/OFF
The selector dial can be turned either clockwise or
pilot light
anticlockwise.
Position
At the end of the programme the selector dial
must be turned to position O.
Attention!
If during a washing programme the selector dial is
turned to another programme, the pilot lights of the
programme progress display start to flash and the
buzzer sounds. The machine will not perform the
new selected programme.
.
9
is on position ,
corresponds to "cold wash".
and the