Start The Programme; Select The Desired Options - Zanussi FE 1004 User Manual

7. Select the spin speed or the
RINSE HOLD option
Press the SPIN SPEED button repeatedly, in order
to select the desired spin speed or the RINSE HOLD
option. The relevant light will light up.
If you select the RINSE HOLD option, the machine
will stop at the end of the programme with the water
still in the tub.

8. Select the desired options

If your laundry is very dirty, it may be advisable to
select the PREWASH option.
If you wish the laundry to undergo an extra rinse,
select the SUPER RINSE option.
Press the OPTIONS button so as to cause one or
both of the lights to light up.
Select the QUICK WASH option, if your laundry is
only slightly soiled. The relevant light illuminates.

9. Start the programme

Press the START/PAUSE button. The relevant light
will stop flashing, the DOOR LOCKED light will light
up, and only the light relevant to the phase that is in
progress will remain lit.
10. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
Changing the type of fabric or temperature is
possible, obviously, only during the washing phase.
When you make a change in these two parameters,
the washing machine will resume the cycle from the
beginning.
If it is necessary to drain the water in order to
change the programme in progress, proceed as
follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the RESET button repeatedly, until
only the DRAIN light
• press the START/PAUSE button again.
When the water has been drained, you may select a
new programme and press the START/PAUSE
button to start it.
17
remains lit;