If The Machine Is Not Working - Zanussi FCS 720C Instruction And Installation Book

If the machine is not working

Symptom
The machine will not start.
The machine is not filling with water.
The machine is discharging water at
the same time as filling.
The machine will not empty or spin.
The machine is leaking or overflowing.
The machine is vibrating or noisy.
The machine door will not open.
Check
Have you pressed the ON/OFF button?
Is there power to the machine?
Has the fuse blow?
Is the door closed properly?
Have you set the programme control knob
properly?
Is the water tap turned on?
Is the water tap turned on?
Has your domestic water supply been cut off
temporarily?
Is the water intake hose kinked or blocked?
Is the filter inside the intake hose blocked?
Is the water pressure too low?
Is the end of the discharge hose too low down?
(See Installation)
Is there a proper air gap between the end of the
discharge hose and the wall standpipe? (See
Installation)
If the machine needs to be emptied manually:
release the discharge hose from the plastic clip
on the machine rear. Lower the end of the hose
to floor level, letting it empty into a suitable
container.
Did you select a programme without drain and
spin?
Is the discharge hose kinked or blocked?
Is the discharge hose extension not correct?
(See Installation)
Have you used too much detergent?
Have you been using the detergent for automatic
machines?
Are the hoses correctly installed? (See Installation)
Is the detergent compartment blocked?
Have you removed all the transit locking devices?
Has the machine been installed on a suitable
surface and levelled?
Is the machine knocking against a wall?
Is the machine standing firmly on all four feet?
Did you wait 2-3 minutes after the end of the
programme and has the indicator light gone out?
Read the section
opening. Never try to force the door open.
Contact service.
- 12 -
Loading the machine on door