Battery Installation Information - Tiger Electronics LAZER TAG Deluxe 2 Player System 71094 Instruction Manual

TO INSERT BATTERIES
Using a Phillips/cross
head screwdriver, loosen
the screw in the battery
compartment cover of
each TAGGER (screw stays
attached to cover). Remove
cover. Insert 6 x "AA"/R6
alkaline batteries. Replace
cover and tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers'
instructions;
2. Do not mix old and new batteries or alkaline,
standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert item correctly
by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard
(carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for
a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and back on
again or removing and re-inserting batteries)
if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any
other types of battery. Always remove from the product
before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
3