Quick Start Guide - Tiger Electronics Lazer Tag IRT-2X Tagger 71985 Instructions Manual

QUICK START GUIDE

For a quick, "Grab & Go" game of LAZER TAG, simply
follow these steps:
1. Press the TRIGGER to wake your TAGGER up.
2. Verify that the power-up SFX are played, and "LTAG"
appears on the LCD screen.
3. Press the Trigger to start the Classic LAZER TAG
"LTAG" game. All players should press their triggers
together, so that everybody starts at the same time.
4. The LCD Screen will display a 10-second countdown
during which time the players should take their
desired positions.
5. At T-0 the TAGGER will say "GOOD LUCK" and the
game will begin.
6. Aim and get tagging!
The Classic LAZER TAG game is an "individuals" game, which
means that all other players are your opponents. The winner
is the last player not tagged out. Each player has unlimited
reloads, 15 seconds of shields, and is tagged out after receiving
10 tags from other players.
After a player is tagged out, their Game Timer will continue to
run for another four minutes. The tagged-out player may switch
between the Game Timer display and the time at which he was
tagged-out by using the
has cheated by restarting their TAGGER in mid-game will have a
much lower Game Time than anyone else, so players can check
each others' timers to ensure no player has done this.
A TAGGER will go to sleep if there is no activity for four minutes
after being tagged out. To maintain your game timer longer than
OK
this, press once a minute or so until the game is over for all
players, then you can compare timers.
Classic LAZER TAG is not a Hosted game, so it does not require
Hosting and Joining the way the other more advanced games do.
It also does not support Debriefing and Scoring at the end of
the game.
To turn your TAGGER off, press 2nd F + CANCEL.
If you'd like to start
another game, just press
the TRIGGER!
IMPORTANT NOTE:
your TAGGER is functioning
improperly or stops functioning, try pressing the Reset Button.
1
INC DEC
and buttons. Any player who
If