Tiger Electronics Lazer Tag IRT-2X Tagger 71985 Instructions Manual page 17

Hasbro interactive lazer tag irt-2x tagger instruction manual
Table of Contents

Advertisement

T-Minus countdown time. This indicates that it is time for the
DUAL TAGGER to be programmed with the primary TAGGER unit's
Player ID. To do this:
1. Turn your back to the Host and walk approximately 10 feet away
from all other players.
2. Point both IRT-2X TAGGER units down at a light-colored spot just
in front of your feet, or on a wall approximately 2 feet away.
3. Press the TRIGGER on the primary TAGGER.
The primary TAGGER will make a "woo-woo-whoop" sound effect
to indicate that it is synchronizing with the Dual TAGGER.
You will then hear the Dual TAGGER make a "ta-dah" sound
effect, and both IRT-2X TAGGER units will display the T-Minus
countdown, to indicate that the synchronization has been
completed successfully.
If you hear an error sound, like a buzz, and your secondary
TAGGER unit's screen is displaying "???-" with a countdown,
it means your secondary IRT-2X TAGGER became confused
and your two TAGGER units are not synchronized. To redo the
synchronization process do the following:
1. Continue to point both IRT-2X TAGGER units down at the
spot just in front of your feet, or at the same spot on a wall
approximately 2 feet away. The secondary TAGGER will soon
display either the T-Minus countdown (if it is able to synchronize
by itself) or else return to the "PRG-" display if it fails to
synchronize. In this case:
a. Press the TRIGGER on the primary TAGGER again.
b. Repeat every 2-3 seconds until successful.
NOTE: If the TAG MASTER TAGGER is to be used in Dual TAGGER
Mode during a game, you must wait until the T-Minus countdown
reaches T-20 or less before you can program your secondary
TAGGER. This is to allow all of the other players time to receive
the T-Minus countdown from the TAG MASTER TAGGER before it
has to divert its attention to programming a secondary TAGGER.
NOTE: The "Tx:" Player ID does NOT appear on the secondary
TAGGER in Dual TAGGER Mode until synchronization/programming
has been completed successfully.
Once you have successfully programmed your secondary
TAGGER, you will begin the game in Dual TAGGER Mode! Each
of your IRT-2X TAGGER units has half the number of reloads and
half the number of tags it can take until being out of the game,
but you can engage twice as many opponents at the same time!
In addition, you can continue to launch tags from one while
the other is reloading, and if you practice launching alternating
bursts of tags from the two TAGGER units you will be able to
keep up a constant barrage of tags without ever overheating.
Each of your IRT-2X TAGGER units will have the same game time
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lazer tag team ops irt-2x tagger71985

Table of Contents