Table of Contents
Advertisement
112
Configuring the DVR
In order to access the DVR remotely, the DVR Server must be setup to allow remote connections.
Time Out Value
Center Port
Image Port
Search Port
Configuring the Server for Remote Connection
1.
Enter Setup on the DVR.
2.
Click Network to open the Network menu.
3.
Clear the Disable Remote Control check box. You should now be allowed to adjust port settings if necessary.
Note
If you are using a Firewall, it may be necessary to adjust the port settings on both the DVR and the Firewall.
Contact the Network Administrator for more information.
4.
Click OK.
5.
Make sure a user account is created (See Creating a New User in the Setup Section). Without a user account, the Administrator
account must be used.
6.
The DVR server is now ready to receive incoming connections.
Specifies a value (in seconds) to wait for a signal
from the Surveillix Remote Client. If a signal is not
received by that time, the connection is dropped.
Used to transfer the connection data.
Used to transfer the image data.
Used to transfer the search data.
Advertisement
Table of Contents
