Table of Contents
Advertisement
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So the
bulb can be replaced. (Bulb type: T 25 230-240 V,
25 W, E 14 thread)
After changing the bulb replace the cover, snap it in
place and apply voltage to the appliance.
If something does not work
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating
sound). This is not trouble, but means normal
operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
12
Advertisement
Table of Contents
