Advertisement
INSTR-Fish Attractor
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER'S MANUAL
WARNING: Do not attempt to operate fishing light
if styrofoam housing, cord, clips, bulb
or any part of the fishing light is
damaged or corroded.
Step 1
Make sure to turn engine off before placing light in
water. To activate, connect one of the red clips to
positive (+) battery post, then connect the other red
clip to negative (–) battery post, chassis or engine
block.
WARNING: Keep battery clips dry and
WARNING: Do not place light in water when lamp
WARNING: If boat is an inboard, the blower must
Step 2
To deactivate, remove red clip from negative (–)
battery post, chassis or engine block, then remove the
other red clip from positive (+) battery post.
WARNING: Always disconnect light from
• Cover the battery clips with a light coating of marine
grade grease to help protect metal parts from corrosion.
• Hang your fishing light above picnic table, campsite or
work area for use as an area light.
• Your fishing light can also be used as a spotlight or
emergency/signal light.
6/8/01
6:24 PM
Page 5
OPERATING INSTRUCTIONS
BEFORE OPERATING THIS FISHING LIGHT.
out of water at all time.
is hot. Light must be disconnected
from power source and cooled before
placing in water. Sudden extreme
changes in temperature could cause
bulb to shatter.
be activated to remove combustible
fumes prior to connecting light.
power source and allow to cool
for at least one minute before
removing light from water. Sudden
extreme changes in temperature
could cause bulb to shatter.
BATTERY CONNECTION
HELPFUL TIPS
2
Advertisement
