Engine Oil And Oil Filter Cartridge - Yamaha Grizzly YFM66FAV Owner's Manual

To install
1. Place the panel and the seat under
bracket in the original position.
2. Install the rear carrier by installing the
bolts and tightening them to the specified
torques.
Tightening torques:
Carrier bolt (top):
26 Nm (2.6 m·kgf, 19 ft·lbf)
Carrier bolt (under fenders):
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
3. Install the seat.
EBU10992

Engine oil and oil filter cartridge

The engine oil level should be checked before
each ride. In addition, the oil must be changed
and the oil filter cartridge replaced at the inter-
vals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Remove panel F. (See page 8-13 for
panel removal and installation proce-
dures.)
2. Place the ATV on a level surface.
3. Start the engine, warm it up for several
minutes, and then turn it off.
4. Wait a few minutes until the oil settles.
8-15