Table of Contents
Advertisement
7. Shopping symbol
Visible, when the appliance runs in shopping cooling
mode. See also the chapter
on using the refrigerator.
Display background colour
By default the display background is blue.
While whatever button or knob is used the background
turns bright blue and remains so for a while.
The display background turns red, if the temperature inside
the freezer is too warm (alarm). If this is the case, the digits
show blinking the warmest temperature inside the freezer,
the high temperature symbol flashes and an acoustic alarm
signal is shown.
The temperature might be too warm in the following cases:
Immediately after switching on
The freezer door was left open for a longer time
There is an operating trouble in the freezer
To switch the alarm sound off press the "E" button. The
display returns to showing the ambient temperature,
however the background remains red until the freezer cools
down properly.
Should you press no button during alarm, press the "E"
button when the sound finishes to see the warmest
temperature reached during the alarm.
Using the Appliance
Putting it into use
Place the accessories into the appliance then plug to the
mains socket.
Press the "A" button. The backlight of the display turns on.
The applince is ready to use.
Pressing the "A" button again the appliance is off, but still
under voltage.
Controlling the temperature, setting
The thermostats interrupt the cooling automatically for more
or less time depending on the setting then restarts it
assuring the required temperature.
Temperature of the refrigerator and freezer can be set by
knobs "F" and "B", respectively. The set temperature is
seen blinking on the display.
For everyday use medium setting, i.e. +5°C in the
refrigerator and colder than -18°C is the freezer is
recommended.
Allow the appliance to run for a period of 24 hours
whenever the temperature setting is changed. This will
allow the temperature to stabilise inside the appliance.
The temperature coming about in the refrigerator is effected
by not only the position of the thermostat but the ambient
temperature, frequency of door openings and the quantity
of food put into it newly, etc.
When the coldest temperature possible is set - in
case of increased demand e.g. during heatwaves
- the compressor may operate continually. This does
not cause damages to the appliance.
How to use the refrigerator
For adequate cooling developing interior air
circulation is necessary. For this reason you are
asked not to cover the air circulation gaps behind the
shelves (e.g. with tray etc.).
Do not put hot food into the refrigerator. Allow
it to reach room temperature naturally. In this
way the unnnecessary frost building up can be
avoided.
Foods can take over odours from each other.
So it is essential to put foods in closed dishes
or wrap them in cellophane, aluminium foil, grease-
proof paper or cling film before placing them into
the refrigerator. This way foods will keep their
moisture e.g. vegetables will not dry out after some
days.
7
Advertisement
Table of Contents
