Yamaha BEARTRACKER YFM250XP Owner's Manual page 114

6. Clean the oil strainer and oil filter with sol-
vent.
7. Inspect the O-ring and replace if dam-
aged.
8. Install the oil filter, O-ring, and oil filter
cover.
9. Replace the oil strainer, compression
spring, O-ring and drain bolt. Then, tight-
en the drain bolt and oil filter cover bolts
to the specified torques.
CAUTION:
_
Before installing the drain bolt, be sure to
install the O-ring, compression spring and
oil strainer.
_
Tightening torque:
Drain bolt (engine):
43 Nm (4.3 m·kgf, 31 ft·lbf)
Oil filter cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
10. Fill the engine with oil and install the dip-
stick.
Recommended oil:
See page 5-7.
Oil quantity:
Periodic oil change:
1.5 L (1.3 Imp qt, 1.6 US qt)
With oil filter replacement:
1.6 L (1.4 Imp qt, 1.7 US qt)
Total amount:
1.8 L (1.6 Imp qt, 1.9 US qt)
CAUTION:
_
Be sure no foreign material enters the
crankcase.
_
11. Warm up the engine for several minutes
at idle speed. Check for oil leakage while
warming up.
8-7