ZANKER ZKV1530 User Manual
ZANKER ZKV1530 User Manual

ZANKER ZKV1530 User Manual

Dishwasher zkv1530
Hide thumbs Also See for ZKV1530:

Advertisement

User manual
Dishwasher
ZKV1530

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZKV1530 and is the answer not in the manual?

Questions and answers

Summary of Contents for ZANKER ZKV1530

  • Page 1 User manual Dishwasher ZKV1530...
  • Page 2: Table Of Contents

    Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
  • Page 3: Safety Information

    Safety information In the interest of your safety and to ensure the ried out by inexperienced persons will cause correct use, before installing and first using the injury or serious malfunctioning. Contact appliance, read this user manual carefully, in- your local Service Force Centre. Always in- cluding its hints and warnings.
  • Page 4: Control Panel

    Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
  • Page 5 IMPORTANT! In this case the programme has to be cancelled: 1. Press and hold the Programme selection/ Always remember that when performing oper- Cancel button until the light of the running ations such as: programme turns off and the End of pro- •...
  • Page 6 Programme selection/cancel button • Starting the washing programme: 1. Press the On-Off button. 2. Press the Programme selection/cancel button once, the light of the last performed washing pro- gramme illuminates and the End of programme light flashes. 3. Press the Programme selection/cancel button as many times as necessary to illuminate the light corresponding to the desired programme.
  • Page 7: Audible Signals

    Indicator lights Saltindicator light Illuminates when the special salt has run out. Is never illuminated while a washing programme is running. Audible signals Audible signals have been introduced to help 4. After a few seconds: indicate which operations the dishwasher is –...
  • Page 8: First Use

    Programme Degree of soil Type of load Programme description Normal 65° Normal soil Crockery, cutlery, pots Prewash and pans Main wash 2 intermediate rinses Final rinse Drying Eat - load - run Light soil Crockery and cutlery Main wash Final rinse 30 min.
  • Page 9: Set The Water Softener

    salt function and other 1. Fill up the rinse aid dispenser with rinse aid. 2. Set the rinse aid dosage to position 2. additives: If you decide in future to use separated deter- there is no need to fill up with special salt or gents, we advise that you: rinse aid.
  • Page 10: Filling With Dishwasher Salt

    Adjusting the water hardness Use of salt Water hardness setting °dH °TH mmol/l manually electronically < 4 < 7 < 0,7 level 1 Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or Setting the water softener current level set.
  • Page 11: Filling With Rinse Aid

    Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. ter. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added.
  • Page 12: Adjusting The Dosage Of Rinse Aid

    Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max" the lid and press until it locks. CAUTION! Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent).
  • Page 13: Loading Cutlery And Dishes

    Open the lid. Set the dosage level. (The Close the lid and press un- dose is factory set in po- til it locks. sition 4). Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each other.
  • Page 14 For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is spe- pearls handles. cially marked as being dishwasher-safe by the man- ufacturer.
  • Page 15: Upper Basket

    Load upper basket. Light For taller items, the cup If plates are to be loaded in the upper basket: load items (plastic bowls etc.) racks can be folded up- them starting from the rear positions; tilting them must be loaded in the up- wards.
  • Page 16: Use Of Detergent

    IMPORTANT! IMPORTANT! Never lift or lower the basket on one side only When the basket is in the higher position you will not be able to use the cup racks. Use of detergent IMPORTANT! Observe the manufacturer’s dosing and stor- age recommendations.
  • Page 17: Care And Cleaning

    The dishes should therefore be allowed to CAUTION! cool down before removing from the appli- When the washing programme has finished, it ance. is recommended that the dishwasher is un- • Empty the lower basket first and then the plugged and the water tap turned off. upper one;...
  • Page 18: Cleaning The Spray Arms

    Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms Prolonged periods of non- operation NEVER try to remove the spray arms.
  • Page 19: Environment Concerns

    3. Remove the water inlet and discharge ho- Avoid over tilting the machine during transpor- ses. tation. 4. Pull the machine out together with the ho- ses. Environment concerns ponents are identified by markings, e.g. >PE<, The symbol on the product or on its >PS<, etc.
  • Page 20 Fault code and malfunction Possible cause and solution • continuous flashing of the start/cancel indicator • The water tap is blocked or furred with limescale. light Clean the water tap. • 1 intermittent audible signal • The water tap is turned off. Turn the water tap on.
  • Page 21: Consumption Values

    Mod. :......PNC : ......S.N.
  • Page 22: Technical Data

    Consumption values Programme Programme duration (in Energy consumption (in Water (litres) minutes) kWh) Intensive 70° 85-95 1,8-2,0 22-25 Normal 65° 105-115 1,5-1,7 23-25 Eat-Load-Run 65° 1,05 Eco 50° (Test pro- gramme for Test Insti- tutes) Rinse and Hold Technical data Dimensions Width x Height x Depth (cm) 59,6 x 81,8-87,8 x 55,5...
  • Page 23: Installation

    Upper basket Cutlery basket Lower basket cup racks: position A Installation WARNING! WARNING! Any electrical and/or plumbing work required to Only use, for connection to the water mains, install this appliance should be carried out by a new hose-set; old hose-set must not be reused. qualified electrician and/or plumber or compe- CAUTION! tent person.
  • Page 24: Drain Hose

    If the water inlet hose leaks, the safety valve Therefore do not immerse the water inlet hose cuts off the water supply. or the safety valve in water. Take care when installing the water inlet hose . Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve.
  • Page 25: Electrical Connection

    Electrical connection WARNING! The dishwasher must be secured against tilting. CAUTION! Therefore make sure that the counter it is fixed Safety standards require the appliance to be under, is suitably secured to a fixed structure earthed. (adjacent kitchen units cabinets, wall). Prior to using the appliance for the first time, This dishwasher is designed to be fitted under ensure that the rated voltage and type of supply...
  • Page 28 www.electrolux.com 156989550-00-042008...

Table of Contents