Yamaha BANSHEE YFZ350S Owner's Manual page 128

Throttle cable adjustment
After the jet needle clip positions are changed,
throttle cable adjustment may be necessary.
1. Move the throttle lever a few times.
2. Push the throttle lever forward until it
stops and hold it in this position.
3. Check through the window of each carbu-
retor to see if the punch mark on the throt-
tle valve is at the specified position.
a
0–1mm
( 0–0.04 in )
a. Specified position
4. If not, loosen the locknuts and turn the
adjusters until proper position is obtained.
q
1. Locknut (×2)
5. Move the throttle lever a few times and
recheck the position.
6. Install the fuel tank, side cover, radiator
cover and air filter case cover.
7. Reconnect the fuel hoses.
8. Install the seat.
8-25
w
2. Adjuster (×2)