Yamaha BANSHEE YFZ350P Owner's Manual page 127

Assembly
1. Reassemble the needle valves, floats and
float chambers.
2. Install the carburetors.
3. Reassemble the throttle valves.
4. Install the carburetor caps and tighten
them securely to the specified torque.
Carburetor cap tightening torque:
4 Nm (0.4 m0kg, 2.9 ft0lb)
5. Install the securing plates. Match one of
the projections on the carburetor cap with
one of the indents on the securing plate.
1. Securing plate
cC
If the securing plate does not match a pro-
jection, tighten the carburetor cap until
they align. Do not loosen.
6. Tighten the securing plate screw to the
specified torque.
Tightening torque:
3.5 Nm (0.35 m0kg, 2.5 ft0lb)
7. Tighten the joint screws of each carbure-
tor.
8-24
q