Yamaha SX225A Owner's Manual page 75

EMK26112*
Lubrication
1) Remove the spark plugs, and spray a 5
second spray of "Yamaha Stor-Rite
Engine Fogging Oil" into each cylinder.
Grease the spark plug threads and rein-
stall the spark plugs and torque to prop-
er specification. (Refer to "CLEANING
AND ADJUSTING SPARK PLUG".)
2) Turn the engine over with the stop
lanyard disconnected to work the fog-
ging oil into the piston rings.
3) Fill the oil tanks. This prevents the for-
mation of condensation. For models
with a remote tank, it may be necessary
to manually override the control unit to
completely fill the engine main tank.
(Refer to Oil level warning section).
4) Change the lower unit oil. (Refer to
"CHANGING GEAR OIL"). Inspect the
oil for the presence of water which indi-
cates a leaky seal. Seal replacement
should be performed by an authorized
Yamaha dealership prior to use.
5) Grease all grease fittings. (Refer to
"GREASING")
EMK27110
Cleaning and Anti-corrosion Measure
1) Wash down the exterior of the outboard
with fresh water and dry off completely.
2) Spray the engine's exterior with
"Yamaha Silicone Protectant" (Part
No. LUB-SILCNE-13-00).
cC
Do not spray when the engine is running.
Also, do not spray near the silencer and
oxygen sensor cover or into the engine.
Otherwise, the oxygen sensor for Electronic
Fuel Injection system could be damaged.
3) Wax the cowling with a non-abrasive
wax such as "Yamaha Silicone Wax"
(Part No. ACC-11000-15-02).
4-6
E