Table of Contents
Advertisement
Performing a power-on test
You are now ready to perform a power-on test to check if the scanner is operating correctly.
1.
Check whether you have unlocked the scanner.
2.
Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the voltage in your area. Double-
check whether the voltage indicated on the back panel of the scanner corresponds with the
voltage in your area. If not, call your dealer.
3.
Switch on the scanner.
The scanner performs a self-test during which the info indicator blinks slowly. This takes about
15 seconds or less. After the self-test the info indicator remains on.
If a malfunction is detected during the self-test, that is, if the info indicator starts blinking at a
higher frequency, refer to
Appendix C,
"Troubleshooting".
Chapter 1 — Preparing the scanner
11
Advertisement
Table of Contents
