Cable Connector Drive Carrier - Accusys ACS-7630 User Manual

Chapter 3 – Setting up the controller

Cable connector drive carrier

The ACS-7630 should be fitted with three hard disk drives (HDDs). Load each drive into a
drive carrier as follows:
1. Unlock the drive carrier and slide it out of
the controller box
2. Place the disk drive at an angle in the drive
carrier and connect the power connector
to the disk drive
3. Carefully connect
connector to the drive carrier connector.
4. Slide the disk drive into position in the
carrier, taking care not to damage the IDE
or power cables.
5. Secure the disk drive by screwing it to the
drive carrier case.
6. Slide the loaded disk drive carrier into the
ACS-7630 Controller Box and lock it.
the drive's IDE
The disk carrier connector at the back of each controller box disk carrier slot
can be damaged if the disk carrier is not properly aligned when inserted.
Insert the disk carrier gently to avoid damage.
21