Connecting The Ac Power Plug; Eco-Power/Standby Features; Setting The Clock - VIETA L'orfeo VTM75R Owner's Manual

Connecting the AC Power Plug

Connect the mains cable to the AC Power Socket (AC~) on the unit and the mains socket on wall,
then your unit is ready to use.
Caution:
Be sure to unplug the mains plug from the mains socket when going out or when the unit is not in use
for an extended period of time.
Where the mains plug is used as the disconnect device, the disconnect device shall remain readily
operable.

ECO-Power/Standby Features

1. The system will automatically switch to "Standby" mode if you do not press any buttons within 15
minutes and the LED indicator is on.
2. The unit will enter "ECO-Power" mode if no button is pressed within 90 seconds.
3. When iPod is in docked, it should not go to Eco-standby mode automatically.
When iPod is NOT in docked, it should go to Eco-standby mode automatically.
Caution: When turning the system on, the system comes on ready to continue in the mode it was in
when last turned off.
When the system is connected to the power, the dock iPod begins to charge.

Setting the Clock

 Setting the Clock Manually
1. The unit automatically goes to "Standby" mode for clock setting in the first time, the unit will
display with clock blink " - - : - - ".
2. Press the Clock button (
3. Set the hour with the Volume Down button (
4. Press the Clock button (
5. Set the minute with the Volume Down button (
6. Press the Clock button (
Note:
• When the clock setting time for each step is longer, the clock setting mode will be cancelled.
• If a power failure occurs or the unit is disconnected from the mains, the clock setting will be lost.
 Setting the Clock Automatically
Tune into a RDS station and wait for a few minutes. To confirm, press the Clock button (
 Display the Clock
In standby mode, press the Clock button (
At ECO-Power mode, press (
clock.
NE-203i_Mouse remote_3 Nov 09.indd 9
) twice, the hour indicator will blink.
CLOCK
) or Volume Up button (
VOL-
), the minute indicator will blink.
CLOCK
VOL-
), then the built-in clock starts operating.
CLOCK
CLOCK
) or (
CLOCK DISPLAY
9
VOL+
) or Volume Up button (
).
) button on the remote control to display the
).
).
VOL+
).
CLOCK
2009-11-3 14:18:33