Assembly - VEXILAR Boundary Waters LC-10 Operation Manual

ASSEMBLY

Set the battery tray down and place the unit, face down,
inside. Line up the bracket holes and install the gimbal
knobs. Make sure the rubber washers are in place. Turn the
knobs in, but tighten only slightly.
INSTALLING THE BATTERIES
Turn the unit over to access the battery compartment
door. Unscrew the two retaining screws and remove the
compartment door. The screws are restricted from falling
out so you don't need to worry about losing them. Install
eight AA batteries (not included) by following the imprint-
ed guides in the battery compartment. Use
N C rechargeable batteries. Replace the compartment
I AD
door and tighten the screws back into place.
Make sure that the power cord from the battery pack is
plugged into the bottom (3 pin) jack on the LC-10 and that
the retaining ring is screwed
down tight.
Note— The battery com-
partment is not sealed. Water
may leak inside. After use, , if
it is wet inside, remove the
batteries and leave the com-
partment open. This will allow
it to dry and minimize any
corrosion that may develop.
4
or
ALKALINE
Figure 4