Attaching The Sensor - VEXILAR 107 PRO Operation Manual

ATTACHING THE SENSOR ASSEMBLY
The speed and tempera-
ture sensor assembly attach-
es to the transducer as
shown. Pinch, or squeeze,
together the tabs at the top
of the sensor and slide the
assembly down into the
tracks on the back of the
transducer. Push it down
until it stops, and then, push
the tabs back outward until
the catches snap into the
holes on the transducer.
ALTERNATE SENSOR MOUNTING
If you plan on mounting the transducer inside the hull
of the boat or on an electric trolling
motor (described on page 11) you
will need to use the provided sen-
sor mounting bracket, instead of the
transducer to mount the sensor.
CAUTION - It is a good idea to restrain the speed wheel
from spinning freely while trailering the boat. Damage may
result because there is no water to lubricate the wheel bear-
ings. A rubber band works good for this.
7
Figure 5
Figure 6