Connecting To A Stereo System - Toshiba SD190EKB Owner's Manual

IMPORTANT!
-If your TV only has a single Antenna In jack (or
labelled as 75 ohm or RF In), you will need an RF
modulator in order to view the DVD playback on
the TV.
Use the composite video cable (yellow) to connect
A
the DVD player' s VIDEO (CVBS) jack to the video
input jack on the RF modulator (cable not supplied).
To hear the sound of this DVD player through your
TV, use the audio cables(white/red) to connect
AUDIO OUT (L/R) jacks of the DVD player to the
corresponding AUDIO IN jacks on the RF modulator
(cable not supplied).
Use the RF coaxial cable (not supplied) to connect
B
ANTENNA OUT or TO TV jack on the RF modulator
to the ANTENNA IN jack on the television.
Connect the Antenna or Cable TV service signal to
C
the ANTENNA IN or RF IN jack on the RF modulator.
(It may have been connected to your TV previously.
Disconnect it from the TV.)
Helpful hint: Before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.

Connecting to a Stereo System

Stereo system has Dolby Pro Logic or Right/Left
Audio In Jacks
Select one of the video connections (CVBS VIDEO
A
IN, SCART IN or COMPONENT VIDEO IN)
depending on the options available on your TV.
Use the audio cables (white/red) to connect AUDIO
B
OUT (L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the stereo system
(cable not supplied).
Connections