Advertisement

Quick Links

MANUAL DE INSTRUCCIONES
INSTRUCTION BOOKLET
LAVAVAJILLAS
DISHWASHER
ZI 609

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZI 609

  • Page 1 MANUAL DE INSTRUCCIONES INSTRUCTION BOOKLET LAVAVAJILLAS DISHWASHER ZI 609...
  • Page 2 Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre relative to the area in which the appliance is to be installed, within twenty days of the date of purchase. (See list of Zanussi network centres).
  • Page 3: Table Of Contents

    CONTENTS Warnings ...............page 22 Installation .
  • Page 4: Warnings

    Care must be taken to ensure that the appliance does not stand on the electrical supply cable or on the water inlet and drain hoses. Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher.
  • Page 5: Installation

    INSTALLATION Remove all packaging before positioning the For making the connection itself, the coupling nut fitted machine. to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose-made quick-coupling tap such as the Press- Positioning Block.
  • Page 6: Use

    Control panel 2 3 4 5 THE CONTROLS 1. ON/OFF button In this fully integrated appliance the controls are locat- ed on top of the door. When selecting a programme, Press this button to preset the dishwasher to accept the door needs to be partially opened. settings (selection of wash programmes, drying Audible signals have been introduced to help indicate options, delayed start, etc.).
  • Page 7 5. Intensive programme light 8. Cancel / programme change button This pilot light comes on when the most energetic pro- If you wish to cancel a programme which is already gramme is selected (no. 2 INTENSIVE) with hot pre- running or a setting which has just been made, press wash, suitable for pans and particularly dirty crockery, this button for about two seconds until the short to remind you that this programme requires an extra...
  • Page 8: The Water Softener, Filling With Salt

    The Water Softener - 5 seconds after this button has last been pressed, the machine returns to programme setting mode and Water contains varying amounts of lime and mineral memorises the level set. salts depending on the area in which you live: these Important are deposited on the dishes leaving white marks.
  • Page 9: Use Of Rinse Aid, Use Of Detergent

    Rinse Aid To open the dispenser lid, pull the catch (D). This will This liquid gives the dishes a shiny finish and open it. improves drying. It is automatically added during the At the end of any washing hot rinse. The dispenser, which is positioned inside programme the lid is always the door, holds about 110 ml of rinse aid, which is open, ready for the next...
  • Page 10: Loading The Machine, Use Of The Lower Basket, Use Of The Upper Basket

    Loading your Machine The cutlery basket is in two parts which can be Before placing dishes in the machine, remove any separated to give greater scraps of food from the plates (small bones, loading flexibility. To separate toothpicks, fish bones, scraps of meat and vegetables, the two parts, slide them hori- fruit skins etc.) to avoid clogging the filters and zontally in opposite directions...
  • Page 11: Adjusting The Height Of The Upper Basket

    Caution Adjusting the Height of the Upper Basket To ensure proper water If washing very large plates (over 27 cm and up to 31 cm distribution to the upper in diameter) you can load them in the lower basket after basket, do not place moving the upper basket to the higher position as follows: dishes over the hole in...
  • Page 12: Washing Programmes

    PTP22GB...
  • Page 13: Operating Sequence

    Operating Sequence 7 Starting the wash programme Open the water tap. 1 Check that the filters are clean (see cleaning instructions) Close the dishwasher door. An audible signal lasting about 1 second informs you that the programme has been started. 2 Check that there is salt and rinse aid If a delayed start has been selected, the dishwasher starts the countdown and the number of hours to go...
  • Page 14: Maintenance And Cleaning

    MAINTENANCE AND CLEANING Cleaning the Central Filters Internal and External Cleaning (After each wash) You must ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned Inspect the central filters (B) and (C) and remove any regularly with a damp cloth.
  • Page 15: Prolonged Periods Of Non-Operation

    Prolonged Periods of Non-Operation If you are not using the machine for any period of time you are advised to: unplug the appliance and turn off the water; fill the rinse aid dispenser; leave the door ajar to prevent the formation of unpleasant smells;...
  • Page 16: Servicing

    SERVICING Certain problems are due to lack of simple maintenance or oversights and can be solved easily without having to call out an engineer. Therefore before calling the Service, consult the check list here below. The following alarms, in the form of letters (A, C, F, L, H, P) flash in the digital display window. The dishwasher fails to start or stops during operation;...
  • Page 17 The dishwasher is not level or is not properly built-in. If, after the above checks, the fault persists, call your local Zanussi Service Centre. Please make sure you give the model and serial number of the appliance. This information can be found on the rating plate lo- cated on the right-hand side of the dishwasher door (see picture).
  • Page 18: Building-In

    BUILDING-IN Building-in features Mounting of decor panel onto the door The height of the panel depends on the height of the This dishwasher is designed to be fitted under a kitchen plinth of adjacent kitchen units (see kitchen plinth counter or sink. adjustment).
  • Page 19 Fixing to the adjacent units Levelling Insert the two fixing brackets Make sure that the dishwasher door closes properly, into the slots provided in the without rubbing on sides. Otherwise level the machine top front part of the by slightly screwing or unscrewing the two front feet dishwasher, as shown in the until perfect closure of the door is reached.
  • Page 22 Printed in Italy 0/1096 152995 41/0...

Table of Contents