Play-Doh 20176 Instruction Manual

Thank you for purchasing this PLAY-DOH Brand toy!
This set includes 2 three-ounce cans of PLAY-DOH Brand Modeling Compound
(Net Weight 6 oz., 170 grams), saw, shape half mold and file.

TO INSTALL BATTERIES

Using Phillips screwdriver, loosen screws
in battery compartment cover (screws stay
attached to cover). Remove cover. Insert 2
x 1.5V "AA" or R6 size batteries. Alkaline
batteries recommended. Replace cover and
tighten screws.
CAUTION: TO AVOID BATTERY
LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert
item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline
batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away
from other electrical equipment. Reset (switching off and back on again or removing and
re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always
remove from the product before recharging. Recharge batteries under adult supervision.
DO NOT RECHARGE OTHER TYPES OF BATTERIES.
© 2004 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
P/N 6395680000
Circular Saw
Questions? Call: 1-800-327-8264
AGES 3+
FOR NEW PRODUCTS AND OFFERS
FOR NEW PRODUCTS AND OFFERS
20176