Table of Contents
Advertisement
RPC-1 Control Panel
When you install the RPC-1 driver, a dedicated RPC-1
application "RPC-1 Control Panel" will be installed
together with the driver.
How to start up the "RPC-1 Control Panel"
• Windows: "Start" > "Settings" > "Control Panel"
> "Roland RPC-1 H/W"
• Macintosh: Double click the "RPC-1 Panel" icon
copied manually.
Main functions of RPC-1 Control
Panel
• Set parameters for the functions of the RPC-1
• Input/output level meters
• Input/output mixing, etc.
Signal flow
R-BUS
1/2
3/4
IN
5/6
Patchbay/Router
7/8
1/2
3/4
OUT
5/6
7/8
MIDI IN
MIDI OUT
The signal flow is as shown in the diagram.
• R-BUS In
• WavOut
• Monitor Mixer
• MIDI In, MIDI Out
are used as the software input/output.
The signals that are output from the R-BUS of the RPC-1 can
be selected in the control panel. For details refer to
"Patchbay/Router page" in this chapter.
OS/Software
1/2
3/4
R-BUS
5/6
In
7/8
Monitor Mixer
1/2
3/4
WavOut
5/6
7/8
MIDI IN
Monitor Mixer
MIDI OUT
RPC-1 Control Panel
6
5
7
1. Save button
Assign a name to the settings and save them. (On the
Macintosh, select "Save" from the "File" menu.)
2. Delete button
Delete saved settings. (This function does not exist on the
Macintosh.)
3. Load button
Load the saved settings. (On the Macintosh, select "Open"
from the "File" menu.)
The RPC-1 Control Panel always retains the last settings
entered. So, you don't have to save the setting every time you
close out the panel. However the Save, Delete, and Load
functions expand this capability to store different sets of
control panel settings using different configuration file
names. These configurations are then available for recall at a
later date and time.
4. H/W Installed
If multiple RPC-1 units are installed, select the RPC-1 for
which you wish to make settings. For details on how the
RPC-1 units are numbered, refer to p. 17 "Using multiple
RPC-1 units."
1
2
3
4
11
Advertisement
Table of Contents
