LG 22LQ630H Owner's Manual page 4

Never touch this apparatus or antenna during
11
a thunder or lighting storm.
When mounting a TV on the wall, make sure
12
not to install the TV by the hanging power and
signal cables on the back of the TV.
Do not allow an impact shock or any objects to
13
fall into the product, and do not drop onto the
screen.
Keep the packing anti-moisture material or
14
vinyl packing out of the reach of children. Anti-
moisture material is harmful if swallowed. If
swallowed by mistake, force the patient to
vomit and visit the nearest hospital. Additionally,
vinyl packing can cause suffocation. Keep it out
of the reach of children.
CAUTION concerning the Power Cord :
15
It is recommend that appliances be placed
upon a dedicated circuit; that is, a single outlet
circuit which powers only that appliance and
has no additional outlets or branch circuits.
Check the specification page of this owner's
manual to be certain.
Do not connect too many appliances to the
same AC power outlet as this could result in
fire or electric shock.
Do not overload wall outlets. Overloaded wall
outlets, loose or damaged wall outlets,
extension cords, frayed power cords, or
damaged or cracked wire insulation are
dangerous. Any of these conditions could
result in electric shock or fire. Periodically
examine the cord of your appliance, and if its
appearance indicates damage or deterioration,
unplug it, discontinue use of the appliance, and
have the cord replaced with an exact
replacement part by an authorized servicer.
Protect the power cord from physical or
mechanical abuse, such as being twisted,
kinked, pinched, closed in a door, or walked
upon. Pay particular attention to plugs, wall
outlets, and the point where the cord exits the
appliance.
Do not move the TV with the power cord
plugged in. Do not use a damaged or loose
power cord. Be sure do grasp the plug when
unplugging the power cord. Do not pull on the
power cord to unplug the TV.
Do not stick metal objects or any other con-
16
ductive material into the power cord. Do not
touch the end of the power cord while it is
plugged in.
WARNING - To reduce the risk of fire or
17
electrical shock, do not expose this product to
rain, moisture or other liquids. Do not touch
4
the TV with wet hands. Do not install this
product near flammable objects such as
gasoline or candles or expose the TV to direct
air conditioning.
Do not expose to dripping or splashing and do
18
not place objects filled with liquids, such as
vases, cups, etc. on or over the apparatus (e.g.
on shelves above the unit).
GROUNDING
19
(Except for devices which are not grounded.)
Ensure that you connect the earth ground wire
to prevent possible electric shock. (i.e. a TV
with a three-prong grounded AC plug must be
connected to a three-prong grouned AC
outlet) If grounding methods are not possible,
have a qualified electrician install a separate
circuit breaker.
Do not try to ground the unit by connecting it
to telephone wires, lightening rods, or gas
pipes.
Short-circuit
Breaker
Short-circuit
DISCONNECTING DEVICE FROM MAINS
20
Mains plug is the disconnecting device.
The plug must remain readily operable.
As long as this unit is connected to the AC wall
21
outlet, it is not disconnected from the AC
power source even if you turn off this unit by
SWITCH.
Do not attempt to modify this product in any
way without written authorization from LG
Electronics. Unauthorized modification could
void the user's authority to operate this prod-
uct.
ANTENNAS
Ground Clamp
22
Outdoor antenna grounding
If an outdoor antenna is installed, follow the
precautions below. An outdoor antenna system
should not be located in the vicinity of
Electric Service
overhead power lines or other electric light or
Equipment
power circuits, or where it can come in contact
with such power lines or circuits as death or
serious injury can occur.
NEC: National Electrical Code
Be sure the antenna system is grounded so as
Power
Supply
Short-circuit
Power
Breaker
Supply
Power
Supply
Breaker
Antenna Lead in Wire
Antenna Discharge Unit
(NEC Section 810-20)
Grounding Conductor
(NEC Section 810-21)
Ground Clamps
Power Service Grounding
Electrode System (NEC
Art 250, Part H)
Electr
E