Table of Contents
Advertisement
General Description
Installing Batteries in the Remote Control
1
Open the battery compartment
cover on the back side.
2
Insert two 1.5V AAA size batteries
in correct polarity. Don´t mix old or
used batteries with new ones.
3
Closed the cover.
The batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
External Connection
Antenna connection
Antenna input impedance of this unit is 75ohm. VHF/UHF 75ohm coaxial cable can be
connected to the antenna jack directly, if the antenna cable is 300ohm parallel flat feeder
cable, you need to use the 300ohm/75ohm converter to connect the antenna cable to the
antenna jack. For details Please refer to the following drawing.
Antennas with 300 flat twins Leads
Use a 75ohm - 300ohm converter
300ohm coaxial cable
Installing Batteries
ANT IN
Antenna feeder
Point the remote towards the remote
control sensor of the TV and use it
within 8 meters.
Put the used batteries into the recyc-
ling bin since they can negatively
affect the environment.
Antennas with 75 Round Leads
75ohm coaxial cable
16
INPUT
MENU
PROG
VOL
Antenna cable
Advertisement
Table of Contents
