Caring For The Cd-Rw/Dvd-Rom Ultrabay Serial Ata Drive; Loading A Disc; Manually Ejecting A Disc - Lenovo ThinkPad User Manual

v Handle a disc by the edges or the center hole. Do not touch the surface of a disc.
v To remove dust or fingerprints, wipe a disc from the center to the edge with a soft, lint-free cloth.
v Do not write on the surface of a disc.
v Do not place a disc in direct sunlight.
v Do not use commercial cleaners to clean a disc.
v Do not bend a disc.

Caring for the CD-RW/DVD-ROM Ultrabay Serial ATA Drive

To protect your drive during operation, observe the following precautions:
v Remove the disc from the drive before moving the drive.
v Do not insert foreign objects into the drive.
v Do not stack objects on the drive.
v Do not remove the drive cover or attempt to service the drive.
v Do not operate the drive under any of the following conditions:
– High temperature, high humidity, or direct sunlight
– Excessive vibration, sudden shock, or inclined surface
– Excessive dust

Loading a disc

1. Press the Eject button. The tray slides out of the drive.
2. Place a disc in the tray with the label facing up.
3. Close the tray by gently pushing the tray in until it latches.
Attention: Do not use force or insert foreign objects to open the tray. If your tray does not open when you press the
Eject button, see "Manually ejecting a disc" for more information.

Manually ejecting a disc

If you press the Eject button and the tray does not slide out, turn off the computer and straighten a large
paper clip to form a tool, as shown in the illustration. The straightened end must extend at least 45 mm
(1.8 inch). Insert the extended end into the manual-eject hole on the front of the drive. Push the paper
clip until the tray opens. Gently pull out the tray until you can remove the disc.
4
ThinkPad CD-RW/DVD-ROM Ultrabay Serial ATA Drive User Guide