Location; Door Reversal - Zanussi ZU 790 F Instruction Booklet

Location

This appliance is designed to be built-in to a space
having the dimensions given in the Figure.
100-170
D506
The height of the appliance can be altered if required
by means of adjustable feet situated at its base.
Door reveral
D507
Remove the two screws which fix the upper hinge to
the door.
Carefully lean the appliance on its back and remove
the plastic insert.
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge to
the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
Take the hinge removed from the upper part of the
appliance on the opposite side, and, using the
screws removed from the lower part, fix it to the base
D447
of the appliance itself.
Remove and refit the other hinge on the upper part
of the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges.
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.
D510
14