Harman Kardon AVR80 Owner's Manual page 27

AVR80 manual 11/01/98 13:01
Automatic
Station Preset Selection
This process automatically scans the AM
and FM bands and enters all stations with
proper signal strength into the memory.
To automatically preset the tuner's
memory, follow these steps:
1. Select the tuner as the unit's input by
pressing the button
AM/FM
2. Using the
TUNE ^ j
the first station you wish to preset at the
low end of the AM or FM band.
3. Start the automatic tuning preset by
simultaneously pressing
on the front panel
TUNE
⁄
station tuned in step #2 will be entered
into the tuner's memory as
MEMO £ AUTO MEMO fi
and
indicators will flash. The display will
show increasing frequencies to indicate
that the auto scan is in progress.
4. Each time the tuner finds a station the
scanning will pause and the station will
be played for five seconds. During this
time you have the following options:
a. To enter the station in the next
open memory position, no action is
needed. After five seconds the tuner
will enter the station and the preset
number will be visible at the far left
side of the main information display.
b. The frequency band may be
changed by pressing the
button .
3 c
Side 21
Basic Operation
c. If the tuner is scanning FM
stations, the
from
AUTO
FM MODE
d. If you do not wish to enter the
current station into the preset
memory, press the
on the front panel or remote.
^ j
. 5. After the desired action is completed, or
3c
five seconds elapse, the tuner scan will
buttons, select continue. The operation will stop
automatically when all 30 preset
positions are filled or when both
frequency bands have been completely
tuned, whichever comes first. To stop the
and automatic preset process at any time
MEMO
. The press the
Ú ^
CLEAR
selection button.
. The
CH 1
Manual Tuner Preset
Stations may be manually entered into
the tuner's memory in any order. Manual
entry is performed from the remote
control only.
1. Tune to the desired station as outlined
in Tuner Operation Section.
2. Press the
MEMO
note that the
flash.
3. While the indicator is flashing for the
next 5 seconds, enter a number from 1 to
30 using the number buttons on the
remote . Any number may be used,
m
but if another station has already been
programmed into the location number
FM/AM
selected, the previous setting will be lost.
21
may be changed
MODE
to mono by pressing the
button .
Ù
button
TUNE ⁄
4. When the preset memory has been
properly programmed the
indicator
Station Name Preset
In addition to identifying stations by their
broadcast frequency or by the RDS system
each preset station manually may be
button or any input assigned a name using alphanumeric
Û
characters. This enables you to identify a
station by its call letters, program format,
or any other five character phrase.
To enter a station name, first preset all
stations you wish to program into the
tuner's memory. Then, follow these steps:
1. Tune to the desired preset station.
2. Press the
button and front panel or
Úo
£
indicator will more than three seconds.
M E M O
3. Note that a character on the left side of
the main information display will start to
blink.
4. Enter the first character of the name
using either the front panel
¤
buttons
a. To enter a single digit memory
location, press before the number,
0
or enter the number and wait a few
seconds.
b. If an invalid number (other than
1–30) is entered in error, the display
will flash to alert you that the entry is
invalid and it will return to the
previous frequency display.
MEMO
£
will stop blinking.
button on the
Ú
MEMO
on the remote for
o
TUNE ⁄
buttons or the alphanumeric
^
on the remote.
m
or