Channel Direct Input - Harman Kardon AVR 510 Owner's Manual

Operation
Once the change has been made, press the Set
button and then press the Selector
buttons or the buttons
/
the next output channel location that you wish
to adjust. To adjust the subwoofer level, press
the Selector buttons or the
/
until appears in the
Main Information Display or on-screen
display.
Press the Set button when the name of
the desired channel appears in the Main
Information Display and on-screen dis-
play, and follow the instructions shown earlier
to adjust the level.
Repeat the procedure as needed until all chan-
nels requiring adjustment have been set. When
all adjustments have been made and no further
adjustments are made for five seconds, the
AVR 510 will return to normal operation.
The channel output for any input may also be
adjusted using the full-OSD on-screen menu
system. First, set the volume to a comfortable
listening level using the Volume Control
34 . Then, press the OSD button
to bring up the
Press the Button four times until the
on-screen cursor is next to the
line. Press the Set Button
activate the
(Figure 8).
Figure 8
Once the menu appears on your video screen,
use the buttons to move the on-
/
screen cursor so that it is next to the channel
that you wish to adjust. Then, use the
tons 31 to raise or lower the output level.
Remember, the goal is to have the output level
at each channel be equal when heard at the
listening position.
32 OPERATION
When all adjustments are done, press the
buttons to move the on-screen
to select that it is next to
then press the Set Button
go back to the main menu to make other
buttons adjustments. If you have no other adjustments
to make, press the OSD button
menu system.
NOTE: The output levels may be separately
trimmed for each digital and analog surround
mode. If you wish to have different trim levels for
a specific mode, select that mode and then follow
the instructions in the steps shown earlier.

6-Channel Direct Input

The AVR 510 is equipped for future expansion
through the use of optional, external adapters
for formats that the AVR 510 may not be capa-
ble of processing. When an adapter is connected
to the 6-Channel Direct Input ª, you may
select it by pressing the 6-Ch Direct Input
Selector 37 . The 6-Channel Direct Input may
also be selected by pressing the Input Source
Selector button
the words
Main Information Display
(Figure 1).
LED lights next to
Indicators .
to
Note that when the 6-Channel Direct Input is in
menu
use, you may not select a surround mode, as
the external decoder determines the processing
in use. In addition, there is no signal at the
record outputs or bass management when the
6-Channel Direct Input is in use.
Memory Backup
This product is equipped with a memory backup
system that preserves the system configuration
information and tuner presets if the unit is acci-
dentally unplugged or subjected to a power
outage. This memory will last for approximately
two weeks, after which time all information
must be reentered.
but-
/
/
cursor so
and
if you wish to
to exit the
on the front panel until
appear in the
, and a green
in the Input