Clarity C120 User Manual page 6

C120 INSTALLATION
If you have digital cable or satellite, plug the
R
TV
C120 into the digital cable or satellite box
W
if possible.
Connect the RCA jacks to the output of the
FIG. 5
TV or VCR. Connect the other end of the
cord to both the left and right RCA ports
STEREO MONO
TV
on the C120 base. Next, select "STEREO" on
3.5mm jack
the "MONO/STEREO" switch on the base.
FIG. 6
If the television (or other audio equipment)
has only one RCA port, connect the left (white)
RCA jack from the output into the left (white)
RCA port of the base. The right (red) jack
should remain unplugged on both ends. Next,
Computer
select "MONO" on the "MONO/STEREO"
FIG. 7
switch on the base. See Figure 5.
B. RCA – 3.5mm Mode
This should be used if the television (or other
CD Player
audio equipment) has only a 3.5mm jack.
FIG. 8
This enables the C120 to be used with
computers, CD players, stereos, MP3 players,
MP3 and other related products.
Player
Use the cord with the RCA jacks on one end
and the 3.5mm jack on the other. Plug the
FIG. 9
3.5mm jack into the device and connect the
RCA jacks in the C120 base. See Figures 6
to 9. Next, select "STEREO" on the "MONO/
STEREO" switch located on the C120 base.
10
C120 INSTALLATION
C. Microphone Mode
Use this mode only if an RCA or headset port
connection is not available; for example, older
televisions that may not have audio outputs.
Connect the supplied microphone into the
"Mic" port on the back of the C120 base.
See Figure 10. Place the microphone near
the speaker of the television or stereo. See
Figure 11.
Note: The microphone will pick up any sound
in the room, such as speech, the doorbell, or
the telephone.
Telephone
The C120 has the ability to produce an audible
tone heard through the headset when the
telephone rings. The following step is neces-
sary if telephone ring notification is desired.
First, plug the telephone cord coming from
the wall into the "LINE" port at the rear of
the C120 base. A phone may be connected
to the C120 base by connecting a phone cord
from the C120 port labeled "PHONE" to your
telephone. See Figure 12.
The C120 allows you to use the same phone
wall outlet for both your phone and C120
TV Amplifier.
MIC
FIG. 10
FIG. 11
FIG. 12
11